Power Cord Arrangement - Hitachi RA-08HDF Operation And Installation Manual

SLIDE OUT OF UNIT
1 Remove the four screws which
fasten the base pan to the cabinet
at the side and back.
2 Slide out the unit by pulling the
handles.
After slide in the unit, please install the sealer between the base pan and cabinet to prevent
from entering rain water in case of typhoon. Fasten the unit to cabinet at the side with the
screw, then refit the front cover.
STOPPER
When the screws at the both side of the cabinet cannot be fasten, please use the stopper (a
"L" shape metal plate that is provided in the plastic bag with the sealer) to fix the cabinet and
the base pan located at in front of the unit.
The steps to fix the stopper are as below:
1 Remove the screw which fasten the plastic band
and electrical box to the base pan.
2 Fix and align the stopper into the rectangular
hole of the cabinet.
3 Fasten back the screw to fix plastic band, stopper
and electrical box to the base pan.

POWER CORD ARRANGEMENT

If power cord is withdrawn from left side
of unit, please arrange the power cord as
in figure after installing the front cover.
RA-08HDF/JDF_EN(OI) 17
Handle
Sealer
TEMPERATURE
COOLER
TEST
Control panel
Plastic band
Front cover
(Inside view)
Power
cord
Base pan
– 17 –
15/03/2004, 03:18 pm
95mm
Electrical box
Cabinet
Stopper Base pan
Guider
Minimum
30mm