Keyless Entry; Setting The Liftgate Open Height; Obstacle Detection - Ford 2014 ESCAPE Owner's Manual

Ford 2014 escape
Hide thumbs Also See for 2014 ESCAPE:
Table of Contents

Advertisement

WARNING
Keep clear of the liftgate when
activating the rear switch.

Setting the Liftgate Open Height

1.
Open the liftgate.
2. Manually move the liftgate to the
desired height.
3. Press and hold the control button on
the liftgate until you hear a chime,
indicating programming is complete.
Note: You cannot program the height if the
liftgate position is too low.
The new open liftgate height will now be
recalled when the power liftgate is opened.
To change the programmed height, repeat
the above procedure. Once you open the
power liftgate, you can manually move it
to a different height.
When operating the power liftgate after
you have programmed a lower height than
full-open, you can fully open the liftgate
by manually pushing it upward to the
maximum open position.

Obstacle Detection

When Closing
The system stops when it detects an
obstacle and two short tones sound. Once
you remove the obstacle, you can power
close the liftgate.
Note: Entering your vehicle while the
liftgate is closing can cause your vehicle to
bounce and activate obstacle detection. To
prevent this, let the power liftgate close
completely before you enter your vehicle.
Before driving off, check the instrument
cluster for a liftgate or door ajar message or
warning indicator. Failure to do this could
result in unintentionally leaving the liftgate
open while driving.
Escape (TM2) , enUSA
Locks
When Opening
The system stops when it detects an
obstacle and two short tones sound.
Remove the obstacle to operate the
liftgate.

KEYLESS ENTRY

SECURICODE
KEYPAD
The keypad is located near the driver
window. It is invisible until touched and
then it lights up so you can see and touch
the appropriate buttons.
Note: If you enter your entry code too fast
on the keypad, the unlock function may not
work. Re-enter your entry code more slowly.
E138637
You can use the keypad to:
lock or unlock the doors
program and erase user codes
arm and disarm the anti-theft alarm.
62
(If Equipped)
KEYLESS ENTRY

Advertisement

Table of Contents
loading

Table of Contents