Inversion Du Sens D'ouverture Des Portes - Whirlpool TOP-MOUNT REFRIGERATOR Use & Care Manual

Style 1
1. Bride du tube
2. Tube en cuivre
3. Bague de compression
4. Entrée d'eau de la valve
Style 2
1. Bride du tube
2. Tube en cuivre
3. Bague de compression
3. La machine à glaçons est équipée d'un filtre à eau
incorporé. Si la qualité de l'eau distribuée localement
nécessite un nettoyage périodique, ou si l'eau qui
alimente l'appareil provient d'un puits, il serait utile
d'installer un deuxième filtre dans le tube de
raccordement de ¹⁄₄-po. On peut obtenir un tel filtre à
eau chez le marchand d'appareils électroménagers le
plus proche. Installer le filtre au niveau de n'importe
laquelle des connexions du tube de raccordement.
4. Brancher le réfrigérateur ou reconnecter la source de
courant électrique.
28
Reversing the Door Swing
TOOLS NEEDED:
⁵⁄₁₆-inch hex-head socket wrench, No. 2 Phillips
screwdriver, flat-head screwdriver, ¹⁄₂-inch open-end
wrench, flat 2-inch putty knife.
⁵⁄₁₆
inch Hex-Head Hinge Screw
Door Stop Screw
Sealing Screw (use on top of doors)
SUGGESTION: Reversing the door swing should be
performed by a qualified person.
IMPORTANT: Before you begin, turn the refrigerator OFF,
unplug it, and remove any food from door shelves.
To remove doors from hinges:
1. Keep doors closed until ready to lift free from the
cabinet.
2. Start at the top hinge and work your way down to the
center hinge and bottom hinge. Remove all screws and
components as shown.
3. Open and lift doors off hinges.
NOTE: If you are reversing the door swing, you should
move the handles while the doors are off of the refrigerator.
Follow the instructions in the "Reversing the Door
Handles" section.
To replace doors on hinges:
1. Remove hole plugs covering the screw holes on the
opposite side of the refrigerator using a flat putty knife.
2. Replace the doors.
3. Start at the bottom hinge and work your way up to the
center hinge and top hinge replacing all components
and screws as shown.
4. Line up doors so they are centered between the sides
of the cabinet and parallel with each other.
5. Fill all unused openings with screws or plastic hole
plugs. Moisture will enter any unfilled openings.
NOTE: If the doors are not closing on their own, see
the "Door Closing and Alignment" section.