Gas Supply - Kleenmaid FEG 900 X Instructions For Use Manual

GAS SUPPLY:

The connection must be executed by an authorised person according to the
relevant standards.
This appliance is suitable for use with Natural Gas or LPG-Propane (Check the "gas
type" sticker attached to the appliance).
Before connecting the appliance to the gas main, mount the brass conical
adaptor onto the gas inlet pipe, upon which the gasket has been placed (figures
30a-30b). Conical adaptor and gasket are supplied with the appliance (packed
with conversion kit for use with Natural gas or LPG-Propane).
For Natural Gas models the gas supply is connected to the pressure regulator which is
supplied with the appliance (fig.30b). Adjust the regulator to obtain a test point pressure
of 1 kPa with the wok burner operating at maximum.
For LPG-Propane models the gas supply is connected to the test point adaptor which is
supplied with the appliance (fig.30a) and ensure that the supply pressure is regulated to
2,75 kPa.
The connection must be made at the rear of the appliance (left or right); the pipe should
not cross the cooker (fig. 28).
The terminal not used must be closed off with the plug and gasket supplied.
IMPORTANT: To screw the connecting tube operate with 2 spanners (fig. 29).
30
Fig. 28
Plug
Fig. 29