Kleenmaid FEG 900 X Instructions For Use Manual page 19

BURNERS
These can be removed and washed only with soapy water.
Detergents can be used but they must not be abrasive or corrosive.
Do not use abrasive sponges or pads.
Do not put in dishwasher.
After each cleaning, make sure that the burner-caps, as well as the burners, have been well
wiped off and CORRECTLY POSITIONED.
It is essential to check the correct position of the burner-caps as the least displacement from
the housing may cause serious problems.
Special attention has to be paid in order not to exchange the housing of the two small
burners shown in fig. 13. The burner caps can instead be interchangeable. The inner
ring of Wok burner is partially drilled while the ring of Auxiliary burner is fully drilled.
Make sure that the probe of the safety valve, near to each burner, remains clean so that the
safety valves can work properly.
Check also that the electrodes for ignition are always clean in order to ensure a regular spark
shooting.
Advice for use and maintenance of catalytic panels.
The catalytic panels are covered with special microporous enamel which absorbs and does
away with oil and fat splashes during normal baking over 200°C.
If, after cooking very fatty foods, the panels remain dirty, operate the oven "idling" on max
temperature for about 30 minutes.
These panels do not need to be cleaned, however it is advised to periodically remove them
from the oven (at least the side panels) and to wash them with tepid soapy water and then
wipe off with a soft cloth.
Do not wash or clean with abrasive products or with products containing acids or
alkalis.
The side panels are reversible and when the catalytic microporous enamel degrades, they
can be turned to the other side.
Fig. 13
Burner-cap ring Burner-cap ring
partially drilled fully drilled
19