Powering On The Handset; Attaching The Belt Clip - Toshiba IP4100 Series User Manual

IPedge & Strata CIX
Getting Started
Powering on the
Handset
Attaching the Belt
Clip
2
4. Replace the cover and slide it up into place.
5. Connect the charger AC adapter to
the charger's AC jack.
6. Plug the other end of the adapter into
a standard 120V AC power outlet.
7. Place the handset in the charger with
the display facing forward. The
display on the handset should light up
and the charger LED should turn on.
If it doesn't, reseat the handset or try
plugging the AC adapter into a
different outlet.
8. Place the spare battery in the back
section of the charger. (Pull the
battery latch back to insert the
battery.
Note: Charge each battery completely
(about 10 hours) before using it.
To power on the handset, press End. The handset searches for a base and
connects to the unit with the strongest signal.
To power off the handset, press and hold End for about 4 seconds.
Line up the holes on each side of the handset. Insert the belt clip into the holes on
each side of the handset. Press down until it clicks.
To remove the belt clip, pull either side of the belt clip to release the tabs from the
holes.
TOSHIBA IP4000-series UG November, 2011