Resetting Handsets; Compliance Information - Toshiba IP4100 Series User Manual

Resetting
Handsets
Compliance
Information
IP4000-series UG November, 2011
• computer equipment and DSL modems
• radio-based wireless devices, such as room monitors, wireless controllers, or
wireless headsets or speakers
• florescent light fixtures (especially if they give off a buzzing noise)
• other services that use your handset line, like alarm systems, intercom
systems, or broadband Internet service
If the static is on 1 handset or in 1 location:
• Check nearby for one of the common interference sources.
• Try moving the handset away from a suspected source, or try moving the
suspected source so it's not between the handset and the base.
• There is always more noise at the edges of the base's range. If the handset
displays Searching, try moving closer to the base.
If the static is on all handsets or in all locations:
• Check near the base for the source of interference.
• Try moving the base away from a suspected source, or turn off the source if
possible.
You can reset all the handset options back to the default values; any customized
settings (language, ring tones, volume, etc.), will be lost. (Resetting a handset will
not deregister the handset from its base.)
1. On the handset, press Menu.
2. From the main menu screen, select the Settings icon.
3. On the Settings screen, select Reset settings.
4. When the handset asks you to confirm, press Yes to continue the reset; press
No or End to cancel.
5. When the handset asks you to enter the PIN, enter the 4-digit code used to
access this handset.
6. The handset reboots and restores all user settings to their default value.
FCC Part 15 information
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules, which
establishes limits to provide reasonable protection against harmful
interference in a residential installation. This equipment generates and
can radiate radio frequency energy; if not installed and used in
accordance with the instructions, it may cause harmful interference to
radio communications. However, even in proper installations, there is no
guarantee that interference will not occur.
If you suspect this equipment is causing harmful interference to a radio or
television receiver, try to correct the interference through the following steps:
TOSHIBA
IPedge & Strata CIX
Appendix – Important Information
23