Vivotek IP2111 User Manual page 41

the SMTP server rejects upon any failure. Some ISP may reject the mail if the address is
invalid.
FTP settings
To send the log files described in the above paragraph via FTP, the SMTP server should be
erased. Administrators must enter correct "Primary FTP Server", "Primary FTP user
name" and "Primary FTP password". "Primary FTP remote folder" is the relative
sub-folder in the remote FTP server. If the port of the remote FTP server is changed other
than 21, set the real port to "Primary FTP server port". If the local network is
protected by a firewall to prevent from initiating FTP connection from the remote FTP
server, you may be able to connect to the FTP server but unable to put any file due to
data channel connection failure. Check "Primary FTP passive mode" for passive
transfer solution. Another set of "Secondary" server settings is also provided for backup
connection.
In either e-mail or FTP, the primary server information should be entered first. If the
primary server is not set, the related FTP or email will be cancelled. Note that it may take
time to connect to the secondary server after the first one fails and it may affect some
applications when conditions happen too often.
After everything is set, click on . A warning message will pop out for confirmation.
After clicking on , Network Camera will automatically restart. If "Reset network
at next boot" is kept checked, perform software installation again. Otherwise Network
Camera will boot up according to the new configuration automatically.
Any change made to this page will make the system restart to validate. Make sure
every field is correctly typed before clicking on . If Network Camera fails to response
due to erratic settings, perform the restore procedures and run software installation.
Administrators should notice that the basic network settings including IP address,
subnet mask, default router and DNS servers will be cleared when the network interface
is switched to the other between Ethernet and modem.
- 39 -