Table of Contents
Advertisement
•
Make sure that the work area and blade
in particular are free from metallic
objects such as wire, nails, etc. that
could be thrown out and injure persons in
the vicinity and damage the equipment.
•
Make sure that everyone, including
children and animals, are not in the sod
cutting area. Debris can be thrown out
and injure people and animals.
Using your sod cutter
•
Be sure engine oil is at engine
manufacturer's recommended level.
(Refer to engine manufacturerís manual.)
•
Make sure centrifugal clutch case has
the proper amount of oil per engine
manufacturer.
•
Put the sod cutter into neutral before
starting.
•
Place blade in transport position before
starting.
1.
Position the sod cutter at your starting
point with the blade out of the ground.
2.
Unscrew knob and thread into a desired
hole for the correct depth of cut.
3.
Pull the blade engagement lever up.
4.
Place the shift lever in slow gear (setting
#1).
5.
Pull the throttle while maintaining a slight
down pressure on the handlebar and cut
a short distance, then stop. Put shift lever
in neutral.
6.
Lift the edge of the sod to check the cut
depth.
7.
To change the depth, push the blade
engagement lever down, unlock the
depth lock knob and select the
appropriate hole and repeat steps 3 thru
6.
8.
End cuts by pushing the blade
engagement lever down while holding
the throttle to cut the end of the sod strip
as the blade exits the ground.
CONTROLS
8011-192chg
1
3/4
3/4
1/2
1/2
1/4
1/4
0
depthgauge
23
English-
Advertisement
Table of Contents
