Table of Contents
Advertisement
Before you start
Read this entire manual and understand and
follow all instructions and warnings before
operating the machine.
Operator Tips
•
To engage reverse gear you may need to
rock the machine back and forth while
pulling the shift lever.
•
Stop before shifting gears.
•
Cut going down hill slopes not across or
up slope.
•
End cuts by pushing the blade
engagement lever down while still
holding the throttle to cut the end of the
sod strip as the blade rises.
•
Soil conditions will effect cutting depth.
Readjusting the blade depth may be
required as you move from hard soil to
soft or moist soil conditions.
•
Do not attempt sharp turns while cutting.
It is usually not necessary to water before
cutting. In extreme conditions, such as clay
soil that is very compacted, a simple test as
follows will determine if you need to water
before cutting. Use a garden hand spade,
weed tool, or even a large screwdriver to test
the groundís hardness. You should be able to
push the tool into the ground 2 to 3 inches
with little effort. If you are unable to do so,
then watering may be advisable. Watering the
day before should give sufficient time for the
soil to absorb the moisture. Use your hand
tool to gauge the effectiveness of your
watering. Allow the grass to dry before cutting
to provide adequate traction for sod cutting.
•
Review all of the machineís safety
decals.
•
Use personal safety equipment. (See
"Protective Equipment" section.)
•
Make sure that you are familiar with
safety regulations and shutdown
procedures described previously in the
operatorís manual.
•
Make sure that all guards are in place
and in good condition.
•
Make sure that the blade is in place and
in good condition.
22-
English
CONTROLS
1. Ear protection
2. Protective glasses
3. Protective gloves
4. First aid kit
5. Protective boots or steel-toed shoes
8011-193
1
2
3
5
4
8011-670
Advertisement
Table of Contents
