Nylon Head Installation; Front Handle Installation - Echo SRM-210SB Operator's Manual

NYLON LINE HEAD INSTALLATION
(Use with Plastic Shield)
Tools Required: Head Locking Tool
Parts Required: Nylon Line Head
1. Be sure upper adaptor plate remains on PTO shaft.
2. Align locking hole in upper plate with notch in edge of gear housing
and insert head locking tool (C).
3. Thread line head onto shaft by turning it counter clockwise until
head is tight against upper plate.
4. Remove head locking tool.

FRONT HANDLE INSTALLATION

NOTE
Label shows minimum spacing for front handle location.
1. Position front handle for comfortable operation and secure screws.
G T
RASS RIMMER
O
PERATOR
/B C
RUSH UTTER
' M
S ANUAL
C
MIN
SPACING
11