Echo SRM-210SB Operator's Manual page 24

Grass trimmer/brush cutter

Hide thumbs Also See for SRM-210SB:

Table of Contents

Drive Shaft Upper

1. Loosen clamping knob (A).

2. Pull locator pin (B) and rotate 1/4 turn counter clockwise to lockout

position.

3. Remove attachment.

4. Remove coupler (E) from upper drive shaft assembly by loosening

clamping screw (C) and removing set screw (D).

5. Remove upper flex cable (F), wipe clean, and apply a thin coating of

1/2 oz. (15ml) of grease.

6. Install cable. Make sure that the flex cable fully engages into the

clutch square drive socket.

7. Slide coupler on upper drive shaft until fully seated, and align set

screw hole in coupling with hole in upper drive shaft.

8. Install and tighten set screw (D), and tighten clamping screw (C).

Table of Contents