Lubrication - Echo SRM-210SB Operator's Manual

LUBRICATION

Level 1.
Tools Required: 13 mm Open End Wrench, Screwdriver, Clean rag,
Grease gun P/N 91016
Parts Required: ECHO LUBE
®
Grease.
Gear Housing
1. Clean all loose debris from gear box.
2. Remove plug (A) and check level of grease.
3. Add grease if necessary, DO NOT over fill.
Drive Shaft (Lower)
IMPORTANT
Lower and upper drive shaft must be lubricated with high tempera-
ture automotive grease every 25 hours of operation, otherwise
drive shaft assembly overheating and failure can result.
1. Loosen two (2) screws (B) and remove center locating screw (C).
Pull gear box and shield from drive shaft housing.
2. Pull flexible cable from the drive shaft housing, wipe clean and
re-coat with a thin coating [15 ml (1/2 oz.)] of ECHO
3. Slide the flexible cable back in the drive housing. DO NOT get
dirt on the flex cable.
4. Install the gear housing and shield assembly.
IMPORTANT
Flat edge of washers (D) must be against drive shaft.
TM
8 oz. (P/N 91014) or Lithium Base
LUBE
®
G T
RASS RIMMER
O
PERATOR
TM
.
/B C
RUSH UTTER
' M
S ANUAL
A
B
C
D
23