PEUGEOT 508 Handbook page 29

CHECK (vehicle autotest)
Automatic CHECK
With the key in the ignition on position, all of the
warning lamps for the functions tested are displayed.
they are switched off after a few seconds.
At the same time, an automatic CHeCK
(vehicle autotest) is carried out.
If no "major" fault is found, you can start your
vehicle.
In the presence of a fault
A "minor" fault has been detected: the warning
lamp(s) are displayed then go off.
You can start your vehicle; however, contact a
PeugeOt dealer or a qualified workshop as
soon as possible.
A "major" fault has been detected: the
associated warning lamps(s) remain on
accompanied by the StOP or SeRVICe
warning lamp.
Do not start your vehicle.
Call a PeugeOt dealer or a qualified
workshop without delay.
* According to country.
Manual CHECK
Pressing the "CHECK" button on the
instrument panel starts the manual CHeCK
(vehicle autotest).
this function enables you to recall at any time
(with the key in the ignition on position or with
the engine running), the alerts present.
With the engine running and the vehicle
moving, the instrument panel displays the
warning lamps (in the event of a fault).
the passenger's airbag deactivated warning
lamp* remains on while the airbag is deactivated.
If your vehicle has a BlueHDi engine,
pressing the "CHECK" button gives
you the distance that can be travelled
before engine starting is prevented
automatically.
For more information on the AdBlue
additive, refer to the corresponding
section.
Lighting dimmer control
With the headlamps on, press button B to
increase the brightness of the instruments
and controls and the interior mood lighting or
button A to reduce it.
As soon as the lighting reaches the required
level of brightness, release the button.
®
Monitoring
1
27