Husqvarna K 3000 Cut-n-Break Operator's Manual page 10

• Check that the blade is not in contact with anything
when the machine is started
• Start cutting with the machine running at maximum
speed.
• Start cutting smoothly, allowing the machine to work
without forcing or pressing in the blade. Always cut at
maximum speed.
• Cut in the same direction when cutting into an existing
cut. Avoid cutting at an angle to the previous cut
otherwise there is a risk of the blade jamming or that
the machine can "climb in the cut".
• Always cut from top to bottom (A).
• Remove the cutter and use a crowbar to remove the
material that remains between the cut (B).
• Follow the same saw cut, but further in the work piece
(C), and repeat the work with the crowbar.
WARNING! When cutting vertically,
!
always cut from the top of the cut and
down. Never cut from the bottom of the
cut and up. This can cause a kickback
and result in personal injury.
10 – English
SAFETY INSTRUCTIONS
• Repeat this working method until the required cutting
depth is achieved (D, E).
• The blade guards are designed to easily adapt to how
deep in the work piece the power cutter is moved.
WARNING! Under all circumstances
!
avoid grinding using the side of the
blade; it will almost certainly be
damaged, break and can cause immense
damage. Only use the cutting section.
Do not pull the power cutter to one side,
this can cause the blade to jam or break
resulting in injury to people.
Smooth cutting
To enable smooth cutting, the splash guard must be
adjusted.
• Release the latch.
• Slide the splash guard sideways.
• Lock the latch.