Radio Tuner Operation; Listening To Radio - Hitachi CX-V3 Instruction Manual

RADIO TUNER OPERATION

Listening to Radio

Please note :
Connect the pigtale aerial in the 75ohm Antenna socket on the back of the unit
1. Press TUNER/BAND button to select FM or MW mode. On the remote, press BAND
button to select FM or MW mode.
2. Press or to select a radio station.
Note:
• If you press or
moves up or down incrementally.
• If you press and hold
to increase automatically until a radio station is received.
3. Adjust to the desired sound and volume.
Note:
The last tuned station is retained and recalled when you turn the system on. The tuned
station is stored into memory even if power is disconnected or cut due to temporary power
failure.
Setting Radio Stations into Memory
You may store up to 20 FM stations and 20 MW stations in channel memory.
1. Press TUNER/BAND button to select FM or MW mode. On the remote, press BAND
button to select FM or MW mode.
2. Press or to select a radio station.
3. Press PROG/MEM button, "PROGRMW" flashs on the display.
4. Press "PRESET +" or "PRESET -" to select program channel.
5. Press PROG/MEM button to save into memory. If it has been previously set, the
former station is replaced.
6. Repeat steps 2 to 5 to store additional stations.
Playing Preset Stations
1. Press TUNER/BAND button to select FM or MW mode. On the remote, press BAND
button to select FM or MW mode.
2. Press PRESET +/– to select the desired preset channel.
Improving Reception
MW Reception
Reposition the unit to get better MW reception.
Note: Do not connect to an outside antenna.
FM Reception
1. Plug in supplied FM wire antenna to the FM antenna socket of this unit, fully unwind
the FM wire antenna and position it for best FM signal reception. OR
2. Connect a FM antenna cable (not supplied) from FM antenna socket of this unit to
your home FM antenna socket.
CX V3 English
for less than three seconds each time, the receiving frequency
or for more than three seconds, the frequency continues
13
English
13
14/3/06, 9:48