Section 7-Seat; Adjusting The Back Angle - Invacare Wheelchair Pronto M61 Operating And Maintenance Manual

SECTION 7—SEAT
SECTION 7—SEAT
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the Off position.

Adjusting the Back Angle

Semi-Recline Back Angle
NOTE: For this procedure, refer to FIGURE 7.1.
1. Lift up on the release handle and adjust seat to desired angle.
2. Let go of the release handle to lock the back in position.
Release Handle
NOTE: Office style van seat
is shown. Standard van seat
operates the same way.
FIGURE 7.1 Adjusting the Back Angle - Semi-Recline Back Angle
Fold Down Back Angle
NOTE: For this procedure, refer to FIGURE 7.2 on page 41.
1. Remove the two shoulder bolts and locknuts from the seat hinges on either side of the
seat.
2. Select one of the four back angle positions as shown in Detail "A" of FIGURE 7.2 on
page 41.
3. Reinstall and tighten the two shoulder bolts and locknuts through the desired back
angle setting on each seat hinge.
NOTE: Both seat hinges should be set to the same back angle setting.
Pronto® M51™and M61™with SureStep®
WARNING
40
Office Style
Van Seat
Part No 1125085