Installing/Removing Flip Back Armrests - Invacare Wheelchair Pronto M61 Operating And Maintenance Manual

SECTION 6—ARMS

Installing/Removing Flip Back Armrests

Make sure the flip back armrest release and height adjustment levers are in the
locked position before using the wheelchair.
NOTE: For this procedure, refer to FIGURE 6.5 on page 38.
NOTE: Flip back armrest release lever must be in unlocked position when placing armrest into the
arm sockets.
Installing
1. Slide the flip back armrest into the arm sockets on the wheelchair frame.
2. Install the quick release pin through the rear arm socket and flip back armrest.
3. Lock flip back armrest by pressing flip back armrest release lever into the locked
(vertical) position.
4. Lift up on flip back armrest to make sure the armrest is locked in place.
5. Repeat STEPS 1‐4 for opposite flip back armrest.
Removing
1. Unlock flip back armrest by pulling flip back armrest release lever into the unlocked
(horizontal) position.
2. Remove the quick release pin that secures the flip back armrest to the wheelchair
frame.
3. Pull up on the flip back armrest and remove the armrest from the arm sockets.
4. Repeat STEPS 1‐3 for the opposite flip back armrest, if necessary.
Flip Back Armrest
Rear Arm Socket
Quick Release Pin
FIGURE 6.5 Installing/Removing Flip Back Armrests
Pronto® M51™and M61™with SureStep®
WARNING
Flip Back Armrest
Release Lever
38
Locked
(Vertical)
Unlocked
(Horizontal)
Seat Frame
Front Arm Socket
Part No 1125085