Prepare The Remote Controller; Install The Batteries; Set The Current Time; Address Selector Switch - Hitachi RAR-5J1 Manual

PREPARE THE REMOTE CONTROLLER

Install the batteries.

1
Use two AAA-size batteries.
CAUTION
1. Do not mix new and old batteries, or
different type of batteries together.
2. Remove the batteries when you do
not use the remote controller for 2 or 3
months.
3
Set the current time (Ex: set to 13:30 )
ABOUT ADDRESS SELECTOR SWITCH
Address selector switch is used to prevent
remote controller signal interference in such
circumstance where 2 indoor units are used in
the same room. This switch is not usually used.
(The factory setting is at "A" side.)
For this setting, please make an inquiry to your
sales agent.
2
Push mark
and pull.
Press the
You can fast forward the time by continuously pressing the
1
button.
Time is incremented
Time is decremented
Press (CLOCK) button to set the current time.
2
is lit instead of
blinking. It automatically goes
off in 10 seconds.
Confirm the current time
Press the
(The time display disappears 3 minutes later). If necessary,
readjust the time following the above procedure 1 and 2 .
Remote controller
– 4 –
Open the cover and press the RESET
button with a sharp tip item.
(TIMER) button to adjust to the current time.
(CLOCK) button to check the current time
Address
Address
backside
RESET
18:88 lights up on the current
time display and start
blinking.
Address selector
switch
Switch lever
Do not operate by yourself.