Batteries - Bounty Hunter Camo-LS Owenrs Manual

IN THE FIELD TECHNIQUES
In the No-Motion Pinpoint mode, coil sweep technique is not important. Rather,
user retuning is critical.
The detector does not automatically adjust to changing ground and
environmental conditions; the operator is required to make the adjustment. If
the detector sounds a constant tone over all areas of the ground, retune the
detector by pressing the GroundTrac button.
RETUNING
Keep the coil still, just above the ground surface, and press the GroundTrac button.
Make sure that the spot on the ground you chose for tuning did not contain
metal; pass over the area with the coil again to insure that the detector does
not emit a tone.
TEMPERATURE CHANGE
If the detector moves from one temperature environment to another, or if the
temperature changes, you must retune the detector until the temperature
stabilizes. If you move from a cooler to a warmer environment, the detector may
emit a constant tone; if so, retune. If you move from a warmer to cooler
environment, the detector may lose sensitivity; if so, retune.
PINPOINTING
How To Pinpoint Targets Using The PINPOINT Mode
When you've discovered a target you wish to dig, do the following:
1. Hold the searchcoil about half an inch above the ground, off to the side of
where you think the target probably is.
2. Tap the PINPOINT button. This will put you into the Pinpoint mode. NOTE:
unlike the other modes, this mode does not require the searchcoil to be in
motion to detect a target.
3. Lift the searchcoil slightly, and pass it over the target. The sound will be
loudest over the center of the target.
To Narrow If Down Further:
4. Now that you know about where the target is, again lower the searchcoil to
about half an inch above the ground, near the center of the target but not
right over the top. Tap the button again. The sound will instantly go away.
5. Lift the searchcoil slightly and move it horizontally over the target. The audi-
ble response zone will be much narrower. If you move the searchcoil
around right and left and also forward and back, making an "X" pattern over
the target, you can determine the location of the target usually within an inch
or two.
NOTE: if at any time it seems like the signal may be drifting, just tap the
Ground-Trac button. This restores the signal to its zero level.
16
- Pinpointing

BATTERIES

IMPORTANT:
Always use ALKALINE batteries for optimal performance.
Always remove the batteries for prolonged storage.
DO NOT MIX OLD AND NEW BATTERIES
CHECK THE BATTERIES if your detector exhibits any of the following
symptoms:
G
The unit does not turn on.
1
G
Low speaker volume.
2
G
Unable to tune detector with the discriminate knob.
3
The Low Battery indicator light will come on and stay on whenever the
batteries need replacing. It should flash momentarily when the Power
Switch is turned on.
IMPORTANT:
Your Camo-LS metal detector requires two 9-Volt
ALKALINE batteries.
Follow these steps to install the batteries.
G
Carefully remove the battery compartment door by pressing the release
1
clip on the right side of the door.
G
Snap one battery onto each of the terminals and place the batteries in-
2
side the compartment.
G
Replace the compartment door by carefully inserting opposite side of clip first.
3
Then press down on clip side until battery door snaps into place.
Release
Clip
Alkaline Batteries
5