Table of Contents
Advertisement
Some major points to consider when installing equipment:
1
Never install antennas near or adjacent to telephone, public address or data
communication lines or overhead power cables.
2
Avoid, where ever possible, running antenna coax alongside other cables.
3
Avoid mounting the transmitter in the immediate vicinity of telephone exchanges or
computer equipment.
4
Always use proprietary 50 ohm coaxial cable between the antenna and the
transmitter. If cable runs exceed 5 metres, always use low loss 50 ohm cable
such as RG213, UR67 or equivalent.
Coaxial cable intended for TV, Satellite or CCTV installations is normally 75 OHM
and therefore totally unsuitable for any transmitter installation manufactured by
Scope.
5
Also remember that the performance of the system will be effected by the type of
material the unit is mounted on and its surroundings.
The following is a list of materials that this transmitter will be adversely affected by
if mounted on or if mounted in close proximity to:
a)
Foil back plasterboard
b)
Metal mesh or wire reinforced glass
c)
Metal sheeting, large mirrors or suspended ceilings
d)
Lift shafts
All of the above can reflect radio waves and thereby reduce the capability of the
transmitter to perform its desired functions.
6
The circuit boards within this equipment may be harmed by Electrostatic Discharge
(ESD). Installers should ensure that both themselves and the system's chassis are
grounded before beginning any installation, and should ensure that adequate anti-
static procedures are adhered to at all times.
7
Warning! Never transmit without an aerial attached to the transmitter
8
Warning! Carefully check the Installation section in this manual covering data
pin connections prior to installation. Damage caused by incorrect connection is the
responsibility of the installer!
CONX8E/3
ConneXions II V8 (Euro), Multi Port Version
4
Issue 3
Advertisement
Table of Contents
