Table of Contents
Advertisement
Note: the default comms Baud rate settings are as follows:
PL3 = 9600 Baud
PL1 and PL2 = 1200 Baud
(these are factory set in software and are not hardware adjustable)
PL1 OPTIONAL (10) DRY CONTACTS
PIN
21
13
25
12
24
11
23
10
22
Note: the dry contact option must be specified at time of ordering together with the pre-programmed
messages required for each contact.
7
If the unit is supplied with a sealed lead acid battery, the flying lead connector should be plugged
into the header marked "Battery" (CN2) on the SMPS15 Power Supply unit. The battery will now be
in circuit and the unit will power up (red power LED will light on lower chassis plate). Note: if battery
fuse (F1) requires replacement at any time, use only type 2A Anti-Surge (AS), 1.25".
8
Replace the cover and re-tighten the four retaining screws.
9
Finally, after checking all connections, insert the mains cable supplied into the IEC type
connector located at the base of the unit and plug in to a suitable switched wall outlet. With
mains power applied, the red LED on the base of the unit should be lit.
10
The system is now ready to accept calls from the host terminal. When a call is transmitted, the
green LED on the base of the unit will light momentarily.
Radio Transmission Baud Rate
This is fixed at the factory to suit the pagers supplied and will normally be set at either 512 or 1200
baud
CONX8E/3
ConneXions II V8 (Euro), Multi Port Version
DESCRIPTION
DRY CONTACT NO. 1
9
DRY CONTACT NO. 2
DRY CONTACT NO. 3
DRY CONTACT NO. 4
DRY CONTACT NO. 5
DRY CONTACT NO. 6
DRY CONTACT NO. 7
DRY CONTACT NO. 8
DRY CONTACT NO. 9
DRY CONTACT NO. 10
6
Issue 3
Advertisement
Table of Contents
