Table of Contents
Advertisement
ConneXions II V8 (Euro), Multi Port Version
PREFACE
Important Installation Information
It is the purchasers' responsibility to determine the suitability of this equipment and its derivatives for any
given application, Scope cannot give specific advice in this manual, as each use will require independent
evaluation.
Scope has, wherever possible, employed extra safeguards to monitor the system's performance. Certain
system installations, operational requirements or budgets may, however, limit the effectiveness of these
safeguards. Again, the suitability of the system for any given application must therefore be decided by the
installer and their customer, relative to the application and risk.
Good working practice dictates that a suitable system installation log must be generated, together with a
record of the dates when the system has been manually checked, (with the aid of signal strength meters
etc.) enabling the system performance to be compared with the original installation data.
For UK equipment, Scope has no control of the use and application of the frequencies issued by OFCOM.
Some equipment that is licensed may have greater protection than other equipment which is operated on a
WT Act License Exempt basis.
The supply of this equipment is governed by our standard terms and conditions of sale, which can be found
on the reverse of all order acknowledgements*, proforma invoices*, delivery notes, price lists and invoices.
Alternatively, these can be provided on request.
* Faxed proforma invoices and quotations refer to "conditions available upon request".
Important Safety Information
Scope products are designed to operate safely when installed and used according to general safety
practices. The following requirements should be observed at all times.
Do NOT subject this equipment to:
Mechanical shock
Excessive humidity or moisture
Extremes of temperature
Corrosive liquids
This equipment is designed for indoor use, unless expressly stated otherwise, and must not be used in
classified Hazardous Areas, including areas containing explosive or flammable vapours, unless express
authorisation has been given in writing by the manufacturer. If in doubt, consult your local product dealer for
further information.
Do not obstruct any slots or openings in the product. These are provided for ventilation to ensure reliable
operation of the product and to protect it from overheating.
Only use a damp cloth for cleaning (not liquid or aerosol based cleaners), and ensure that any power is
removed from the unit prior to beginning the cleaning operation.
Removal of covers from the equipment must only be undertaken by authorised service personnel, who
must ensure that power is isolated prior to removal.
CONX8E/3
Issue 3
1
Advertisement
Table of Contents
