Planer Setup; Operating Controls; Power - Jet JJP-8BT Operating Instructions And Parts Manual

screw underneath the chute meshes with three
positioning holes on the table (D
6. Raise the table (turn handle L clockwise) until
the dust chute (B) is held firmly in place
between the planer infeed table (D
jointer outfeet table (D
7. Tighten lock handle (N).
Step 8 is optional.
8. Further secure the dust chute by reinstalling
the hex nut (B ) and flat washer (B
1
underneath the planer infeed table (D
9. Remove handle (L).
Figure 11

9.0 Planer setup

If the machine is currently set up for jointer
operation, remove the dust chute (B, Figure 11).
Refer to the Jointer Setup section above.
Refer to Figure 12:
1. Swing cutter guard (C) away from fence (A),
which will expose the cutterhead.
Figure 12
).
1
) and
1
). Do not overtighten.
2
) from
2
).
1
dangerously sharp. Use extreme caution when
working around them. Failure to comply may
cause serious injury.
2. Orient the dust chute (B) as shown. Install onto
the jointer outfeed table (D
tightening lock knobs (B
Important: Dust chute (B) must be properly
installed in both Jointer setup and Planer setup. If
improper installation fails to activate a micro-
switch, the machine will not start.

10.0 Operating controls

power source before making any adjustments.
Failure to comply may cause serious injury.

10.1 Power

Plug power cord into outlet.
Refer to Figure 13:
Start/Stop
Pull the red switch (A) out to start. Push in to stop.
Safety Key
Removing the safety key (B) will render the
start/stop switch inoperable. The machine can
continue to operate without the key, but upon
stopping cannot be restarted until it is reinstalled.
Reset Switch
If the machine should come to an unexpected stop
during operation due to overload or jammed work-
piece, etc.:
1. Set the start/stop switch (A) set to stop
(pushed in).
2. Momentarily press, then release the reset
switch (C).
3. Restart machine.
11
Cutterhead knives
) and secure by
2
).
4
Disconnect machine
Figure 13
are
from