Planer Controls And Adjustments; Jointer Controls And Adjustments - Jet JJP-8BT Operating Instructions And Parts Manual

10.2 Planer controls and adjustments

Refer to Figure 14:
Table Lock
Turn the lock handle (A) counterclockwise to
release and permit table adjustment. Turn the lock
handle (A) clockwise to secure the planer table (D)
in its selected position.
Table Height Adjustment
The planer table height is set as follows:
1. Unlock the table lock (A).
2. Install the removeable adjustment handle (C)
onto the shaft (B).
3. Rotate the adjustment handle (C) clockwise to
raise the planer table (D), counterclockwise to
lower.
Each revolution of the adjustment handle (C) results
in a 3/32" up or down movement of the table (D). A
scale indicates the amount of table travel. The
pointer (E) indicates the table position on the scale
relative to the cutterhead.
Figure 14

10.3 Jointer controls and adjustments

Refer to Figure 15.
Infeed Table Height Adjustment
Two lock knobs (F) and a height adjustment knob
(E) control the height adjustment of the infeed table
(D).
To adjust:
1. Loosen lock knobs (F).
2. Turn the height adjustment knob (E) clockwise
to raise the infeed table (D) or counter-
clockwise to lower the table.
The amount of table adjustment can be read
on the scale (C).
3. Tighten the lock knobs (F).
Note: A depth of cut of 1/16" or less is recom-
mended.
Cutterhead Guard
Refer to Figure 15.
Properly positioned, the cutterhead guard (A)
should rest against the fence (B
Fence Bevel Adjustment
The fence (B ) can be tilted backward (G) up to
2
45° (that is, for a total included angle of 135° from
table surface) as follows:
12
Figure 15
).
1