Boot From Aec-6896; In Win Nt; Install The Driver - Acard AEC-6896S User Manual

NOTICE: During driver installation, if you encounter the problem of Win-
dows logo, please click "Continue Anyway". Windows logo is a mechanism
designed to prevent OS from working abnormally because of installing
unidentified software. Yet, the driver of AEC-6896 has been proven not to
affect the entire work of OS.

4.1.2 Boot from AEC-6896

Please follow the steps given below to install a new OS to the hard drives con-
nected to AEC-6896. Thus, you can boot from AEC-6896.
(1). Find the support CD containing the driver of AEC-6896 from the package. Copy
the driver into a formatted floppy disk, and label it. Please refer to Appendix B.
(2). If you want to boot from the RAID subsystem, please enter the BIOS of AEC-
6896 to build a RAID into which you intend to install an OS.
(3). Place the original CD of Win 2000 or XP into CD-ROM, and boot from hence.
(4). On seeing the first blue screen, you need to press <F6> to install the OS to the
hard drives connected to SCSI or RAID card. After the installation program
loads needed files, please press <S> and put the driver disk into floppy drive.
(5). The installation program will load the driver of AEC-6896. And you can select
the hard drives or array into which you intend to install the OS. Then follow the
wizard to complete.
(6). During installation, if you encounter the problem of Windows logo, please click
"Continue Anyway".

4.2 In Win NT

4.2.1 Install the Driver

Please follow the steps given below to install the driver of AEC-6896.
(1). After installing AEC-6896, boot the original system again.
(2). Click "Control Panel", "SCSI Adapters", and "Drivers". Then click "Add". Put the
driver disk or CD of AEC-6896 and specify the driver's location.
AEC-6896S/6896 Manual
21