Command Center Wall Installation - Monessen Hearth BLDV400 Installation And Operating Instructions Manual

Figure 51 - Signature Command Wiring Diagram
Electrical connections should only be
performed by a qualified, licensed electri-
cian. Main power supply must be turned
off before connecting fans to the main
electrical power supply or performing
service.
Before installing the blower, turn off the
fireplace and allow to cool. Only a quali-
fied service person should service and
repair the fireplace. A qualified service
person should connect and disconnect
the fireplace to gas supply. Follow all
local codes.

COMMAND CENTER WALL INSTALLATION

The command center may be mounted on the wall with the use of the SCSWEK Kit (15ft.
cable, junction box, wall cover).
Mount the junction box provided at the desired location on the wall. Do not extend beyond
the 15 ft. wire cable provided.
Route the wire from junction box to lower control area at bottom of fireplace. Unplug the
12" cable from control box and command center. Plug the 15 ft. extension cable into the
control box. Remove command center from the fireplace and plug the other end of the ex-
tension cable into the command center. Snap on wall cover provided and screw to junction
box.
74D0009
SIGNATURE COMMAND - ELECTRICAL INSTALLATION
TO JUNCTION BOX
IN FIREPLACE
OPTIONAL {
WHITE
LIGHT
BLACK
OPTIONAL { WHITE
BLOWER BLACK
{
BLACK
OPTIONAL
WHITE
AUX
GREEN
INPUT 300 WATT MAX EACH
OPTIONAL
AC BOX
CONNECTOR
PIN TO CONTROL BOX
CONTROL BOX
CONVERSION
NG/LP
PLUG IN CONNECTOR
CONTROL BOX TO COMMAND CENTER
PLUG IN CONNECTOR
STEPPER MOTOR TO
CONTROL BOX
GROUND
DC POWER/GREEN
PLUG IN CONNECTOR
CONTROL BOX TO
SOLENOID
GAS IN
VALVE
PILOT
RF RECEIVER
ON/OFF BUTTON
BLACK/THERMOPILE
RED/THERMOPILE
SENSING
IGNITER/SPARKER
OFF/LO
MASTER
ON/HI
SWTICH
LED
4-AA BATTERY
COMPARTMENT
COMMAND
CENTER
GAS OUT
PILOT GAS TUBING
37