Pro-Form PCTL04509.0 User Manual page 12

12. Have a second person hold the console assem-
bly near the Right Handrail (104) and the Left
Handrail (not shown). Connect the Upright Wire
(79) to the console wire. See the inset drawing.
The connectors should slide together easily
and snap into place. If they do not, turn one
connector and try again. IF THE CONNECTORS
ARE NOT CONNECTED PROPERLY, THE
CONSOLE MAY BE DAMAGED WHEN YOU
TURN ON THE POWER.
13. Attach the ground wire from the console assem-
bly to the Right Handrail (104) with a #8 x 1/2"
Ground Screw (3). Note: It may be difficult to
turn the Ground Screw.
Set the console assembly on the Right Handrail
(104) and the Left Handrail (107). Be careful
not to pinch the wires. Insert the connectors
and the excess wire into the Right Handrail.
14. Attach the console assembly to the Right and
Left Handrails (104, 107) and the Crossbar (106)
with four #8 x 3/4" Screws (1) and four #8 x 1/2"
Screws (2). Start all eight Screws before tight-
ening any of them. Note: Use the two #8 x 1/2"
Screws that you removed in step 10.
Tighten the six 5/16" x 1" Bolts (6) (only three
are shown).
Tighten the two 1/4" x 3/4" Bolts (10) (only one
is shown).
See assembly steps 4 and 6. Firmly tighten the
four 3/8" x 4" Bolts (9).
12
Console Assembly
Console
Wire
79
104
13
Console Assembly
3
104
14
Console Assembly
10
1
106
6
2
12
Console
Wire
79
Ground
Wire
1
2
104
107
107
2