Mitsubishi Electric FR-A800 Safety Stop Function Instruction Manual page 2

Compliance with the EU Machinery Directive – Functional Safety
WARNING
 Any misuse of safety function could lead to personal injury or death, property damage, or economic
loss. To ensure that the system complies fully with requirement of safety, make a system-level risk
assessment. Mitsubishi Electric Co. cannot assume responsibility for any system to comply with
safety directive.
CAUTION
 The information of this manual is merely a guide for proper installation.
 Mitsubishi Electric Co. cannot assume responsibility for the compliance or the noncompliance to
any code, national, local or otherwise for the proper installation of this equipment.
 A hazard of personal injury and/or equipment damage exists if codes are ignored during installation.
WARNING
 To avoid an electric shock hazard, verify that the voltage on the bus capacitors has discharged
before performing any work on the drive. Measure the DC bus voltage at the P(+) and N(-) terminals
or test points (refer to your drive's
must be zero.
WARNING
 The safety stop function do not isolate electrically between drive and motor. To avoid an electric
shock hazard, disconnect/isolate power to the drive and verify to ensure that the voltage is zero
before performing any work on the motor (refer to your drive's
User Manual for locations and discharging time). The voltage
User Manual for discharging time).
1