Settings For The Speakers - Sony DAV-DZ310 Operating Instructions Manual

enter a new 4-digit password, replace the disc in the
unit and press N. When the display for entering your
password appears, enter your new password.
Changing the password
1
Enter your 4-digit password using the
number buttons, then press
2
Press X/x to select [CHANGE
PASSWORD t], then press
3
Enter a new 4-digit password using the
number buttons, then press
If you make a mistake entering your
password, press C before you press
then input the correct number.
4
To confirm your password, re-enter it
using the number buttons, then press
.
x [DivX (R) VOD]
You can display the registration or deactivation
code for this system, or deactivate this system
after activation.
To display the registration code
Press X/x to select [Registration Code c], then
press .
To deactivate the system
Press C/c to select [YES] or [NO], then press
.
• [YES]: The system is deactivated and the
deactivation code is displayed.
• [NO]: The system returns to the previous
display.
To display the deactivation code again
after deactivation
Press X/x to select [Deactivation Code c], then
press .
For more information, go to
http://www.divx.com on the Internet.
x [MULTI-DISC RESUME]
This system recalls the point where you stopped
the disc the last time it was played and resumes
playback from that point the next time you insert
the same disc.
[ON]: The system stores the resume points in
memory for up to 10 discs.
[OFF]: The system does not store the resume
points in memory. Playback restarts at the
resume point only for the current disc in the unit.
Note
.
• When the resume playback memory is full, the
resume playback point for the earliest disc is deleted.
.
x [RESET]
You can return the [SETUP] settings other than
.
[PARENTAL CONTROL] to the default
settings.
,
Press C/c to select [YES], then press
You can also quit the process and return to the
Control Menu by selecting [NO] here.
Do not press [/1 while resetting the system as
it takes a few seconds to complete.
Note
• The [MEDIA], [INTERVAL], [EFFECT], and
[MULTI/2CH] settings also return to the default
settings.

Settings for the speakers

[SPEAKER SETUP]
You can adjust the speaker settings manually
without performing the Quick Setup.
Select the speakers you will use, set the speaker
distance from your listening position, and then
adjust the sound level for each speaker. You can
adjust the sound level by using the [TEST
TONE] function.
x [CONNECTION]
[FRONT]
[YES]
[CENTER]
[YES]: Normally select this.
[NONE]: Select this if no center speaker is used.
[SURROUND]
[YES]: Normally select this.
[NONE]: Select this if no surround speakers are
used.
.
67
GB