Motion Setup; Ntsc/Pal Output Select; Restart - SecurityMan DVR-04 User Manual

DVR Setup

5.15 Motion setup

The first step is to setup video record method by Motion Triggered. Please refer back to 5.7 Record
Schedule.
MOTION SET
MOT LEVEL
MOT REC TIME
After the "MOTION SET" step is completed, press "
to start the Motion Record feature.

5.16 NTSC/PAL Output Select

Before turning on the DVR, make sure the J10 jumper is on the NTSC setting (for U.S.A) or PAL set-
ting (for Europe).

5.17 Restart

There are two restart modes. First, use the Power Switch to restart the DVR;
second, press the PAUSE key continuously for 12 seconds, it will be hot restarted.
MOT LEVER:
User can press "
of motion detection.
5
25
High(1----------10)Low
MOT REC TIME:
This number indicates the recording time duration
when motion is detected. Press "
time.
Time Set:5sec~30sec
Select" to adjust sensitivity grade
Menu" to exit, and press [
13
Select" to set the
Record ]