Table of Contents
Advertisement
frONT glaSS rEmOval aND iNSTallaTiON
Front Glass Installation
1. Place heater in position. (Check flue and gas
connection positions. refer to gas connection
instructions on page 12 and flue installation
instructions on pages 11)
2. remove the front glass surround by holding it firmly
on either side and pulling it towards yourself.
refer FIG 6.
3. remove the inner glass. Slacken off screws in
top clamp and remove side clamps.
refer to FIG 7.
To Refit The Front Glass Surround
Ensure that the glass surround is replaced the correct
side up. The rearward sloping frame must be at the top
and the vertical edge must be at the bottom.
refer FIG 8.
This heater can be placed on either combustible or non
combustible floor surfaces.
10 | Cannon Canterbury Freestanding
Top: rearward sloping frame
Bottom: vertical edge
fig 6
fig 7
fig 8
Advertisement
Table of Contents
