Honda CRF250X 2006 Owner's Manual & Competition Handbook page 120

Front Suspension Adjustments
21.Clean the threads of the fork protector bolts
(18) and axle holder thoroughly.
Apply locking agent to the fork protector bolt
threads.
Install the fork protectors (19), fork protector
bolts, brake hose clamp bolts (20) and
tripmeter cable clamp bolts (21).
Tighten the fork protector bolts to the
specified torque:
5 Ibf·ft (7 N·m, 0.7 kgf·m)
22.Align the brake caliper (23) and hose with the
left fork leg, making sure that the brake hose
is not twisted. An improperly routed brake
hose may rupture and cause a loss of braking
efficiency. Route the hose carefully.
23.Clean the threads of the caliper mounting
bolts (22) and brake caliper thoroughly.
Apply locking agent to the bolt threads.
Install the brake caliper (23) on the slider and
tighten the caliper mounting bolts to the
specified torque:
22 Ibf·ft (30 N·m, 3.1 kgf·m)
(21)
(19)
(18)
(22)
(18) fork protector bolts
(19) fork protectors
(20) brake hose clamp bolts
(21) tripmeter cable clamp bolts
(22) caliper mounting bolts
(23) brake caliper
116
Adjustments for Competition
24.Check the left side collar (24) and tripmeter
gear box (25) for wear or damage.
Install the left side collar (24) to the left wheel
hub.
Install the tripmeter gear box (25) while
aligning its tabs (26) of the tripmeter gear box
with the grooves (27) on the right wheel hub.
(24)
(24) left side collar
(25) tripmeter gear box
25.Clean the clamping surface of the axle and
axle holders.
Install the front wheel (28) between the fork
legs while inserting the disc between the pads,
and align (29) the tab of the tripmeter gear
(20)
box as shown.
Cjeck that the tripmeter gear box O-ring (30)
(22)
is in good condition, replace it if necessary.
Apply a thin layer of grease to the axle (31)
and insert the axle from the right side.
(23)
(25)
(28) front wheel
(29) align
26.Install and tighten the axle nut (32) to the
(26)
(27)
(26) tabs
(27) grooves
(32) axle nut
(33) left axle pinch bolts
(30)
(29)
(31)
(30) O-ring
(31) axle
specified torque.
65 Ibf·ft (88 N·m, 9.0 kgf·m)
Tighten the left axle pinch bolts (33) to the
specified torque.
15 Ibf·ft (20 N·m, 2.0 kgf·m)
(33)
(32)
(28)