Download Print this page

Protection Led; Signal Outputs; Warranty Regulation - HELIX Dark Blue Instruction Manual

2 and 4 channel high power amplifier
Hide thumbs Also See for Dark Blue:

Advertisement

Available languages

Available languages

Caution! To avoid a lost of sound pressure make sure
that the crossover frequencies of high- and lowpass are
separated of 2 octaves when building a bandpass.
That means: If the lowpass signal is adjusted to 320 Hz the
highpass should be adjusted 2 octaves lower on approx. 80
Hz. (1 octave = double frequency or half frequency)
If a subwoofer is connected we recommend to use high-
pass control 10 as variable subsonic filter or turn it
counter-clockwise to 15 Hz to get a subsonic filter.
12 Lowpass control
To adjust the crossover frequency from 40 Hz to 4000 Hz
Lowpass: 40 - 4 kHz
variabel
2K
40 Hz
13 Power LED
Shows the operation mode of the amplifier.

14 Protection LED

The red LED indicates malfunctions of the amplifier.
The DARK BLUE amplifiers have several electronic protection
circuits that shut off the amplifier at overheating, overloading,
short-circuit on loudspeaker, low-ohmic mode or defective
power supply.
Please check for connecting failures such as short-circuits,
wrong connections and over-temperature.
If the amplifier does not turn on it is defect and has to be send
to your local authorized dealer for repair service. A detailed
description of the malfunction and the purchase receipt has
to be attached.

15 Signal outputs

Full range RCA outputs to connect other amplifiers..
8
Cont. power rating at 4 Ohms per channel measured at 13,8 V . . . . . . . . . . . . . . . . . . . . . . . . 2 x 80/160 Watts RMS/Music
Cont. power rating at 2 Ohms per channel measured at 13,8 V . . . . . . . . . . . . . . . . . . . . . . . . 2 x 120/240 Watts RMS/Music
Cont. power rating at 1 ch. bridged at 4 Ohms . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 x 200/400 Watts RMS/Music
Frequency response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 Hz - 20 kHz, +/- 0,3 dB
Bassboost . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .0 - 18 dB
Setting range highpass . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 Hz - 4 kHz
Setting range lowpass . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40 Hz - 4 kHz
Setting range highpass . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 Hz - 4 kHz
Total harmonic distortion (THD) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . < 0,09%
TIM distortion . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . < 0,016%
Signal to noise ratio . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . > 90 dB
Input impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 kOhms
Input sensitivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .200 mV - 8 V
Fuse . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 x 30 Ampere
Dimensions (H x W x D) in mm . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 58 x 190 x 280
Weight net. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4,7 kg
5K
Hz
4 kHz
Cont. power rating at 4 Ohms per channel measured at 13,8 V . . . . . . . . . . . . . . . . . . . . . . . . 4 x 60/120 Watts RMS/Music
Cont. power rating at 2 Ohms per channel measured at 13,8 V . . . . . . . . . . . . . . . . . . . . . . . . 4 x 100/200 Watts RMS/Music
Cont. power rating at 1 ch. bridged at 4 Ohms . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 x 180/360 Watts RMS/Music
Frequency response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 Hz - 20 kHz, +/- 0,3 dB
Bassboost . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .0 - 18 dB
Setting range highpass . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 Hz - 4 kHz
Setting range lowpass . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40 Hz - 4 kHz
Setting range highpass . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 Hz - 4 kHz
Crossover setting range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 Hz - 4 kHz
Total harmonic distortion (THD) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . < 0,09%
TIM distortion . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . < 0,016%
Signal to noise ratio . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . > 90 dB
Input impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 kOhms
Input sensitivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .200 mV - 8 V
Fuse . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 x Ampere
Dimensions (H x W x D) in mm . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 35 x 240 x 432
Weight net. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4,7 kg
TECHNICAL DATA DARK BLUE 2
TECHNICAL DATA DARK BLUE 4
Gewerbegebiet Lake II · Hünegräben 26 · D-57392 Schmallenberg
Tel.: ++49 (0) 29 72-97 88 0 · Fax: ++49 (0) 29 72-97 88 88
E-mail: info@audiotec-fischer.com · Internet: www.audiotec-fischer.com

WARRANTY REGULATION

Due to the high quality standard Helix products achieved an excellent
international reputation. Therefore we grant a warranty period of
2 years.
The products checked and tested carefully during the entire produc-
tion process. In the case of service note the following:
1) The 2 years warranty period commences with the purchase of
the product and is applicable only to the original owner.
2) During the warranty period we will rectify any defects
due to faulty material or workmanship by replacing or repairing
the defective part at our decission.
Further claims, and in particular those for price reduction, can-
cellation of sale, compensation for damages or subsequential
damages, are excluded. The warranty period is not altered by the
fact that we have carried out warranty work.
3) Unauthorized tampering with the product will invalidate this war-
ranty.
4) Consult your authorized dealer first, if warranty service is nee-
ded. Should it be necessary to return the product to the factory,
please insure that
a) the product is packed in original factory packing in
good condition
b) the warranty card has been filled out and attached to the
product
c) the product is shipped prepaid, i.e. at your expense
and risk
d) the receipt/invoice as proof of purchase is enclosed
5) Excluded from the warranty are:
a) Shipping damages, either readily apparent or concea-
led (claims for such damages must be immediately
notified to the forwarding agent).
b) Scratches in metal parts, front panels or covers etc.
This must be notified to your dealer within 5 days of purchase.
c) Defects caused by incorrect installation or connec-
tion, by operation errors, by overloading or by external force.
d) Products which have been repaired incorrectly or
modified or where the product has been opened by
other persons than us.
e) Consoquential damages to other equipments.
f) Reimbursement when repairing damages by third
parties without our previous permission.

Hide quick links:

Advertisement

loading