Public Address - Vertex Standard VX-2100 Series Operating Manual

C 1 C
ALL TO ALL
Press (or press and hold) the assigned programmable key to send a 2-Tone or 5-Tone
sequential burst which is pre-defined.
DTMF CODE SET
Press (or press and hold) the assigned programmable key to start storing the DTMF
dialing sequence. After completion to enter all DTMF digits, you can transmit the
codes by pressing the PTT key.
C U /D
OWN ( This function is only available in the VX-2200 )
ODE P
Press (or press and hold) the assigned programmable key to select a 2-Tone or 5-
Tone encode code from pre-defined encode list.
C S
ET ( This function is only available in the VX-2200 )
ODE
Press (or press and hold) the assigned programmable key to change the 5-Tone
encodeing digit. To change the tones, select the desired digit using the [ P1 ] / [ P2 ]
keys, then change the number using the [ ] / [ ] keys.
S D
IAL ( This function is only available in the VX-2200 )
PEED
Your Dealer may have pre-programmed Auto-Dial telephone number memories into
your radio.
To dial a number, press (or press and hold) the assigned programmable key, then
press the microphone's key corresponding to the Auto-Dial memory number list
provided by your Dealer if the keypad microphone is using, or press the PTT key if
the normal (without keypad) microphone is using. The DTMF tones sent during the
dialing sequence will be heard in the speaker.
P A
UBLIC DDRESS
Press (or press and hold) the assigned programmable key to use the transceiver as a
PA amplifier.
In the VX-2200, when you enable this function, a tone sounds and "PUBLIC A" will
appear on the display. The public address can be used even while scanning and
receiving a call.
VX-2100/-2200 S
A
DVANCED
3
( This function is only available in the VX-2200 )
O
ERIES PERATING
O
PERATION
M
ANUAL
15