Omron BP710N Instruction Manual page 28

GUIDANCE AND MANUFACTURER'S DECLARATION
Guidance and manufacturer's declaration - electromagnetic immunity
OMRON BP710N is intended for use in the electromagnetic environment specified below. The
customer or the user of this OMRON BP710N should assure that it is used in such environment.
Immunity test
Electrostatic 
discharge (ESD)
IEC 61000-4-2
Electrical fast 
transient/burst
IEC 61000-4-4
Surge
IEC 61000-4-5
Voltage dips, short
interruptions and
voltage variations on
power supply inputlines
IEC 61000-4-11
Power frequency 
(50/60 Hz) magnetic
field
IEC 61000-4-8
Note: U is the A.C. mains voltage prior to application of the test level.
T
IEC 60601
test level
±6 kV contact
±8 kV air
±2 kV for power
supply lines
±1 kV for 
input/output lines
±1 kV line(s) to
line(s)
±2 kV line(s) to
earth
<5 % U (>95 % dip
T
in U )
T
for 0.5 cycle
40 % U (60 % dip
T
in U )
T
for 5 cycles
70 % U (30 % dip
T
in U )
T
for 25 cycles
<5 % U
(95 % dip
T
in U )
T
for 5 sec.
3 A/m
Compliance level
±6 kV contact
±8 kV air
Not Applicable.
Not Applicable.
Not Applicable.
3 A/m
28
Electromagnetic
environment - guidance
Floor should be wood,
concrete, or ceramic tile. If
floors are covered with
synthetic material, the
relative humidity should be at
least 30 %.
Not Applicable.
Not Applicable.
Not Applicable.
Power frequency magnetic
fields should be at levels
characteristic of a typical
location in a typical commercial
or hospital environment.