Invacare ICCG 1143214 Installation And Operating Instructions Manual page 6

IHRAILTS-DLX
Positioning Device
Release Lever
(Towards the foot end
of the bed)
Mounting Pin
Washer
Hex Bolt
Mounting
Bracket
Pivot
Tube
Locknut
Attach Head End Crossmember Here
Using the IHRAILTS-DLX Positioning Device
NOTE: For this procedure, refer to FIGURE 8.
1. Perform one of the following:
• Raising - Pull up on the positioning device while
rotating towards the head end of the bed until
the positioning device locks into place.
• Lowering - Pull up on the release lever and push
down on the positioning device while rotating
towards the foot end of the bed until the
positioning device lowers into place.
Changing the Head Board Mounting Position
NOTE: For this procedure, refer to FIGURE 9.
NOTE: When using bed rails 6815A, 6816A, 6803A or IHRAILTS - DLX in conjunction with an 80-inch mattress, the head board
mounting brackets MUST be adjusted.
1. Remove the two mounting screws that secure head board mounting bracket to the bed frame. See Detail "A".
2. Secure the head board mounting bracket to the bed frame as shown in Detail "B" using two mounting screws and
locknuts. Securely tighten.
NOTE: Ensure mounting brackets are perpendicular to the floor.
3. Repeat STEPS 1-2 to install remaining head board mounting brackets.
ICCI Bed Rails and Accessories
Mattress Deck
FIGURE 7 Installing the IHRAILTS-DLX Positioning Device
Mounting
Bracket
Retaining
Clip
Pivot
Tube
Washer
Positioning Device
FIGURE 8 Using the IHRAILTS-DLX Positioning
6
IHRAILTS-DLX
Positioning Device
Mattress Deck
Crossmember
Retaining Clip
Release Lever
Device
Part No 1143214