STEP#16:
Turn the control switch to the HIGH position. Visually check
to see that the auger is turning. (it revolves once/min)
STEP#17:
Look under the bottom of the unit to see that the fan is
circulating
STEP#18:
AFTER 2-3 minutes of power the hot rod in the fire pot should
be emitting a little heat and may have a faint glow to it.
STEP#19:
Charge the pellet auger. Add food grade wood pellets to
the hopper and watch the fire pot until pellets appear.
(takes approx. 5 – 7 minutes)
STEP#20:
Once a couple of pellets have reached the fire pot...Turn
the control switch to the off position. Then place the
shield over the fire pot so that it is centerend over the fire pot
STEP#21:
Install the
drain.
the drip pan.
STEP#22:
Place the GRILL GRATES onto the grill supports.
with one end sloping towards the catch
DRIP PAN
NOTE: for easy clean up, place a layer of aluminum foil over
heat
.