Using the device
Switching ON/OFF the device
Press the
POWER
will appear and the software will load up.
CAUTION!
If the battery is flat the device will not switch on;
you must charge the battery first.
Switching off the device
After pressing the POWER button the device will ask you
to choose between switching off and stand-by mode.
Stand-by mode means the screen will be temporarily
shut down and when you press the POWER button again
the device will restore the last active screen. Switching off
means that when you press the POWER again the system
will be loaded again.
Pointing pen
The pointing pen is inserted to a slot in the back side of the device.
1. Single click – touch the screen once.
2. Double click – touch the screen twice quickly.
3. Dragging – touch the screen in the starting point than move the pen to the destination.
System reset
If the system seems jammed please use the pointing pen to press the RESET button
(on the back side of the device).
WARNING!
All unstored data will be removed after resetting the system.
button. The welcome screen
9