Saving New Default Settings; Adjusting Room Temperature With Remote Controller; Operating Lines - Oilon GT 5 Operation Manual

a. Press the OK button to access the menu system.
b. Press the Information (i) button for 5 seconds, select Commissioning user
level and press OK button.
3. Take the heating circuit into use.
a. Select Configuration menu and press OK button.
b. Select free heating circuit (5710 Heating circuit 1 or 5715 Heating circuit 2) to
be added and press the OK button.
c. Change the value to On and press the OK button.
d. Select operating line 6200 Save sensors, give value Yes and press OK button.
4. Configure the heating curve and flow temperatures for the heating circuit, see
chapter Configuring heating curve.

2.14. Saving new default settings

If you experience an extended power failure, all settings made will be lost and the
heat pump reverts back to its default factory settings. If you want to keep all settings in
memory, you can save them as new default settings.
1. Press the OK button to access the menu system.
2. Select Configuration and press the OK button.
3. Select operating line 6204: Save parameters and press the OK button.
4. Change the value to Yes and press the OK button.

2.15. Adjusting room temperature with remote controller

Remote controller is an optional extra, these instructions applies only if remote
controller is part of the heat pump delivery.
1. Turn adjusting wheel to increase or decrease comfort setpoint setting.
2. Confirm setting by pressing Operating mode-button.
3. For reduced setpoint, press OK-button. Select program page Heating circuit and
change Reduced setpoint setting.

2.16. Operating lines

The following tables present the most commonly used operating lines in the control
system.
GT02 1408 EN
If you save all current settings as new default settings, the
original factory settings that they replace will be permanently
overwritten.
After changing room temperature setting, wait at least 2 hours
for temperature to adapt.
15 (24)