Table of Contents
Advertisement
Controlling Whirlpool Action
After the electronic controls are set, the whirlpool action in
your bath can be infl uenced by up to three additional factors
– direction of fl ow, force of water, and (whirlpool jet) force of
air. All baths manufactured by Jacuzzi Whirlpool Bath are
equipped with fully adjustable or partially adjustable jets, which
are adjustable for one or more of these factors. Some baths
have only directionally adjustable jets which can be adjusted
for direction and fl ow of air only.
Direction: To change the direction of the water fl ow, swivel
the jet nozzle to the desired angle. The jets can be directed
individually toward any location on your body to provide a
hydromassage. The jets can also be adjusted so that they all
point in the same direction (clockwise or counterclockwise)
to circulate the water in a circular motion around the bath,
causing a total whirlpool effect.
Water Force: The high volume, fully adjustable jets can
be adjusted to control the force of the water coming into the
bath. For robust action, increase the force of the fl ow by
rotating the jet handles to the left (counterclockwise). For a
more gentle effect, rotate the handles to the right (clockwise).
Closing one or more jets can increase the water force in the
remaining jets.. Never run the whirlpool system with all
the jets closed.
Force of Air: Buttons located on the bath control panel
serve as controls for the whirlpool air induction system. The
intensity of the hydromassage whirlpool action is determined
by the amount of air inducted into the water by the hydromas-
sage jets. As the amount of air is increased, the hydromassage
action increases.
JET
ADJUSTABLE
FULLY
21
RapidHeat™
This heater is standard on all units except Mito™ 6. The
Mito™ 6 comes with a heater blank installed. A heater kit (not
provided) can purchased and installed on the Mito™ 6. Follow
the installations instructions provided with that kit if a heater
kit is to be installed at this time.
Operation
Once the heater is installed and the whirlpool pump is oper-
ating, the heating function is totally automatic. The heater will
help maintain the temperature of the water in the bath.
Vacuum/Pressure Switch
The heater is equipped with a preset vacuum switch or
pressure switch which will not allow the heater to turn ON if
the pump is not running and water fl owing through the whirl-
pool system.
Vacuum switch is a water inlet unit.
Pressure switch is a water outlet unit.
High-Limit Switch
The heater includes an exclusive High-Limit switch. This
safety circuit will not false trip from hot tap water. It will only
turn OFF the heater if the thermostat fails. To reset, press the
button. If the high-limit trips frequently, contact your Authorized
Electrical/Mechanical Service Provider. Visit our web site at
http://www.jacuzzi.com/ to fi nd a Service Provider.
HIGH LIMIT RESET
OVER HEAT
PROTECTION
PUSH TO RESET
Jacuzzi Whirlpool Bath EL21000B
HEATER ON
HEATER ON
10/06
Advertisement
Table of Contents
