Salon Control Panels (For Mito™ 6) - Jacuzzi SALON Installation And Operating Instructions Manual

CONTROL PANEL OPERATION
The Mito™ 6 has two control panels, one Air Bath and one Whirlpool.
Control Panel Operation, Mito™ 6 Air Bath Controls
General Functions
Normal Mode: Press this button to turn the blower ON. The blower will be on for 20 minutes. The intensity may be changed
by using either the up arrow button or the down arrow button. Pressing this button a second time will turn the blower OFF. When
the blower is turned off the blower will continue to run for 10 seconds to allow the heater element to cool.
Wave Mode: Press this button to change the blower's power from a minimum to a user defi ned maximum. Press this button
a second time to return to normal mode where the blower's power is constant.
In the Normal mode with the blower power constant, press the UP arrow to increase or the DOWN arrow to decrease. In
Wave mode these buttons change the blower's power to a user defi ned maximum.
Control Panel Operation, Mito™ 6 Whirlpool Controls
General Functions
The Electronic Control ON/OFF Switch, conveniently located on the bath, allows you to turn the whirlpool system on and
off while in the bath. Simply push down on the switch button to turn on the whirlpool system. To turn the system OFF, push
down on the button again.
The control switch will automatically shut OFF after 20 minutes. Push down on the switch button to restart the whirlpool system
again.
Jacuzzi Whirlpool Bath EL21000B
(WHIRLPOOL AND AIR BATH FOR MITO™ 6]
20
10/06