Electrical Installation - MHSC 36STFL Installation And Operating Instructions Manual

ELECTRICAL INSTALLATION

Electrical connections should only be
performed by a qualified, licensed electrician,
main power must be off when connecting to
main electrical power supply or performing
service.
The blower when installed, must be
electrically grounded in accordance with
local codes or in the absence of local codes,
with the National Electrical Code ANSI/NFPA
70.
WIRING TO JUNCTION BOx
NOTE: The wire must be run to the junction box
before framing the firebox.
1. Wire the receptacle into an electrical circuit. Use mini-
mum 60°C wire in accordance to prevailing codes.
. The junction box is preinstalled at the factory. Remove
junction box cover by removing the screw from the
outside firebox wall.
3. The junction box cover has a factory-installed "romex"
style strain relief connector. Connect the wires according
to the wiring diagram below. Route the connected wire
leads through the strain relief connector. Figure 20
WHITE BLACK
Figure 21 -
BLOTDL Blower Wiring Diagram
79D0007
Receptacle
WHITE TAN
Speed Control
Optional Thermostatic Switch
FP2900
BLOTDL blower wiring
FORCED AIR kIT
If you are installing the forced air kit Model BLOTDL on
the LSTF36, LPF36, GCRF36 or GCLF36 units, see the
installation instructions below supplied with kit.
NOTE: For See-through and peninsula models, two
blower kits may be used and will operate independently.
Junction Box
Figure 20 -
Junction Box Wiring Diagram
FP2899
Junction box wiring
120VAC
Junction
Box
BLACK
GREEN
TAN
Lo-Rider Vent Free Fireboxes
ON/OFF Wall Switch or
Optional Variable Speed Switch
Factory Supplied
Not Supplied
10V AC
60 Hz
15