Installation Procedures; Connecting Cables - Konica Minolta bizhub C360 Installation Manual

XXVI. Connecting cables
1. Remove the knockout from the cover located on
the right side of the machine with nippers as
shown in the illustration.
Note:
Take this step only when the machine does not
have the optional paper feed cabinet and the desk.
A0EDIXC034DA
2. Connect the network cable to the machine and
route the cable as shown in the illustration.
Paper feed cabinet and desk installed
A0EDIXC035DA
No paper feed cabinet and desk installed
A0EDIXC036DA
3. Connect the networking equipment (HUB) using
the network cable.
Note:
The following shows the recommended network
cables that correspond to each communication
speed.
• 10BaseT/100BaseTX: Category 5
• 1000BaseT: Category 5E, Category 6
Networkport
LED1
LED2
A0EDIXC032DA
4. Check LEDs for lighting conditions.
LED1:
Should light up steadily if the link network con-
nection has been made.
LED2:
Should blink according to the communications
status of the ACT network.
XXVII. Network setting
Make the TCP/IP address setting for the network.
Note:
Consult the network administrator for the setting
value to be entered and make settings as
required.
1. Select the function to be used as follows:
Utility/Counter → Administrator Settings → Enter
the Administrator Password → Network Settings
→ TCP/IP Settings → IPv4 Settings.
2. Touch "Manual Input" of IP Address Setting
Method and make the following settings.
IP Address: IP address of the controller
Subnet Mask: Subnet mask of the network, to
which the machine is connected
Default Gateway: IP address of the default gate-
way
3. Touch "OK."
4. Turn OFF and ON the Main Power Switch.
5. Select the function to be used as follows:
Utility/Counter → Administrator Setting → Enter
the Administrator Password → Network Settings
→ Forward → Detail Settings → PING Confirma-
tion, and make the operation check of TCP/IP.
INSTALLATION MANUAL
I. Accessory parts
No. Name Shape
1. Original Cover
2. Hinge Cover
(Right)
A0EDIXC028DA
3. Hinge Cover
(Left)
A0EDIXC029DA
4. Screw
(3 × 6 mm)
After unpacking, be sure to get rid of the
packaging materials and keep them out of
the reach of children.
Putting the head in the plastic bag
involves danger of suffocation.
E-8
OC-509
Original Cover
II. Installation procedures
1. Attach the furnished hinge cover (right) and hinge
Q'ty
cover (left).
(three screws furnished with the machine)
1
4599U001AA
1
2. Install the original cover.
1
3
9646
A0EDIXC030DA
A02EIXC038DA