BEFORE USING THE WASHING MACHINE
1.Remove the packaging and check
• After unpacking, make sure that the washing
machine is undamaged. If in doubt, do not use
the washing machine. Contact After-Sales
Service or your local retailer
• Check that the accessories and supplied parts are
all present
• Keep the packing material (plastic bags,
polystyrene parts, etc.) out of reach of children,
as they are potentially dangerous
2.Remove the transport bolts
• The washing machine is fitted with a transport
bolts to avoid any possible damage to the
interior during transport. Before using the
washing machine, it is imperative that the
transport bolts are removed
3.Install the washing machine
• Remove the protective foil from the control
panel
• Move the appliance without lifting it by the
worktop
• Install the appliance on a solid and level floor
surface, preferably in a corner of the room
• Make sure that all four feet are resting firmly on
the floor and check that the appliance is
perfectly level (use a spirit level)
4.Water inlet
• Connect the water supply inlet hose in
accordance with regulations of your local water
company
• Water inlet:
Cold water only
• Tap:
3/4" threaded hose connection
• Water Pressure
(flow pressure): 100-1000 kPa (1-10 bar)
5.Drain hose
• Connect the drain hose to the siphon or hook it
over the edge of a sink by means of the "U" bend
supplied
• If the washing machine is connected to a built-in
pumping out system, ensure that the latter is
equipped with a vent to avoid simultaneous
loading and draining of water (siphoning effect)
6.Electrical connections
• Electrical connections must be carried out by a
qualified technician in compliance with the
manufacturer's instructions and local safety
regulations
• Data concerning voltage, consumption and fuses
are located on the inside of the appliance door
• The appliance must be connected to the mains
exclusively by means of a socket with an earth
connection in accordance with established
regulations. The washing machine must be
earthed by law. The manufacturer declines all
liability for damage to property or injury to
persons or animals due to non-compliance with
the directions given above
• Do not use extension leads or multi sockets
• Before any maintenance on the washing
machine disconnect it from the mains supply
• Access to the mains plug or to disconnection
from mains supply via a double-pole switch must
be ensured at all times following the installation
• Do not operate the washing machine if it has
been damaged during transport. Inform the
After-Sales Service
• Mains cable replacement is only to be carried out
by After-Sales Service
• The washing machine must only be used in the
household for the prescribed uses
Minimum housing dimensions:
Width:
600 mm
Height:
825 mm
Depth:
600 mm
19
Need help?
Do you have a question about the Washing Machine and is the answer not in the manual?
Questions and answers
How do I open door after it has locked?
If the door of a Whirlpool washing machine won’t open, it could be due to several reasons:
1. Water Not Drained: If the machine detects water inside, it will keep the door locked to prevent spills. Ensure the drain is working properly.
2. Door Lock Failure: The door lock mechanism may be faulty and need repair or replacement.
3. Suds Condition: Excess detergent can create too many suds, preventing the door from unlocking.
To fix these issues:
- If water remains inside, try running a drain cycle.
- If excessive suds are present, run a rinse cycle to clear them.
- If the door lock is faulty, it may need to be manually released or replaced.
If none of these solutions work, consult a technician.
This answer is automatically generated
Need maual For Whirlpool AWM 5100