Using The T 752; Selecting Sources; Adjusting The Volume; Muting The Sound - NAD T752 Owner's Manual

USING THE T 752

1 8 1 8 1 8
1 8 1 8
You may operate the T 752 receiver from its front panel or via the HTR 2 remote control. Since the remote
will be the primary controller for most cases, we will focus on remote-controlled operations. Be sure also to
read the section, "Front Panel" above.

SELECTING SOURCES

SELECTING SOURCES SELECTING SOURCES SELECTING SOURCES SELECTING SOURCES
With the HTR 2's remote's [Amp] device selected, the remote's numeric-key section directly selects the
receiver's inputs, plus the internal tuner ([Tuner), Tape Monitor ([Tape]), and multichannel input ([Ext. 7.1/
5.1]) refer to the red labels directly above each key.
• When an audio-only source (CD, DISC, TUNER) is selected, the most recently-selected video signal
remains selected, until another audio-video input is selected
• When you change sources, the VFL will display the new input in its primary display.
• A newly selected input's listening mode (Stereo, EARS, Pro Logic II, etc.) will revert to the mode to which
it is configured on the <Input Settings> line of the setup menu, unless the incoming signal is a Dolby
Digital or DTS source, in which case the input will be set automatically to the appropriate decoding mode.

ADJUSTING THE VOLUME

ADJUSTING THE VOLUME ADJUSTING THE VOLUME
ADJUSTING THE VOLUME ADJUSTING THE VOLUME
Use the HTR 2 remote's <Volume up/down> keys to adjust the "master volume" of the T 752, raising or
lower all channels together. Note that:
• A momentary keypress will change the master volume by 1 dB increments; if you hold down <Volume up/
down> the master-volume change will "run-on" until the key is released.
• The T 752's OSD will show the volume setting as a line graphic with a numeric display above in dB relative
to the reference level.
Since recordings vary considerably in overall average level, there is no imperative to listen at any particular
master-volume setting. A setting of -20 may sound "as loud" from one CD or DVD as -10 does from another.
• If muting has been activated (below), adjusting master-volume via the HTR 2 remote or the front-panel
knob automatically releases the mute function.
• The T 752 will power-up from Standby mode at whatever master volume setting was last used; however,
if the prior setting was greater than –20 dB the T 752 will power up to –20 dB. This prevents inadvertently
beginning a session at excessive volume.

MUTING THE SOUND

MUTING THE SOUND
MUTING THE SOUND MUTING THE SOUND MUTING THE SOUND
Use the HTR 2 remote's <Mute> key to silence all channels completely. Muting is always available,
regardless of source or listening mode selections. Note that:
• Cycling through Standby or powering off does not release muting; the T 752 will return from Standby with
muting on if Standby was invoked with muting on.
• Changing input or listening-mode selections does not release muting.
• Adjusting the master-volume upward via the HTR 2 or the front-panel knob automatically releases the
mute function.

LISTENING TO RADIO

LISTENING TO RADIO LISTENING TO RADIO LISTENING TO RADIO LISTENING TO RADIO
The T 752's internal AM/FM tuner offers very high quality sound from radio broadcasts. Note that reception
and sound quality will always be dependent to a degree on the type of antenna(s) used, as well as proximity
to the broadcast origin, geography, and weather conditions.