PSC Magellan 2200VS Product Reference Manual page 86

Interface Type — continued
CAUTION
NOTE
NOTE
5-38
To select the desired interface:
Great care should be taken to select the correct interface type, since you
can cause damage to the scanner and/or POS terminal by attempting to
change to an incompatible interface. ALWAYS make interface selections
with the host cable DISCONNECTED.
When an interface is selected, the scanner loads the factory configura-
tion for that interface as the selection is made, erasing any and all custom
configuration that may have previously been done.
1. Disconnect current interface cable(s) if currently connected.
2. Scan the SWITCH bar code
3. Scan the bar code representing the appropriate interface located on
the following pages. You'll need to cover any unused bar codes adja-
cent to and on any facing pages to ensure the scanner reads only the
bar code you intend to scan.
4. Complete the programming sequence by scanning the SWITCH
bar code.
Once the correct interface has been set, it will be necessary to proceed to
the appropriate pages in this manual that select parameters and options
for that interface. For example, if RS-232 is selected, turn to the pages in
this manual headed as features specific to the RS-232 interface.
5. Connect new interface cable(s).
®
Magellan 2200VS and 2300HS