PSC Magellan 2200VS Product Reference Manual page 54

NOTE
5-6
It is recommended that programming sessions be limited to one
feature at a time. Should you make a mistake in the programming
sequence, it can be difficult to discover where an error has been
made if several features are programmed at once. Additionally, it
can be confusing to determine which features may or may not have
been successfully set following such a session.
3. Scan the SWITCH bar code to save any new settings and exit Pro-
gramming Mode. The scanner will sound a beep and reset upon
exiting Programming Mode, and the green LED will return to its
usual state (on steady or off ).
The scanner will exit Programming Mode under the following con-
ditions:
— the programming sequence has been completed or the
SWITCH bar code is scanned
— five minutes have passed without scanning activity. Any data
programmed during the current session will be ignored
the scanner will reset and revert to its condition previous to
initiating the exited session.
— power is disconnected. Disconnecting power during Pro-
gramming Mode, before scanning the SWITCH bar code,
will cause all new settings to be ignored. On power-up, the
scanner will return to previous settings.
4. Maintain a good record of all changes made to ensure that you know
if the original factory settings have been changed.
1. Exception: If an interface bar code had been read while in Programming Mode, the scanner will
operate on the default settings for the new interface.
®
Magellan 2200VS and 2300HS
1
, and