Fitting Into The Cabinet - AEG COMPETENCE D2160 Operating And Installation Instructions

FITTING INTO THE CABINET

IMPORTANT: Ensure that the oven is
switched off at the wall before any
further work is carried out.
Using a tape measure establish the internal
width of the cabinet. Refer to page 34 if greater
than 565mm.
Position the cooker in front of the cabinet. See
Fig. 8.
Remove 4 screws which are securing the
product to the wood inserts in the pack base.
(See Fig. 9).
Take out all oven furniture before installation to
reduce the weight you need to lift. The oven
door should be taped up to keep it closed whilst
lifting.
To place the cooker into the cabinet follow the
procedure below:
N.B. Two people will be required to carry
out the lifting procedure.
Warning: Do not attempt to lift this
appliance by the handle(s).
Each person should squat either side of the
cooker.
Tilt the cooker so that your hands can support
the underside of the cooker.
Keeping your back straight, raise the appliance
to the cabinet by straightening at the knees.
Rest the rear underside of the cooker on the
cabinet floor while your hands support the front.
The cooker can be pushed fully into the cabinet.
Take care to avoid damaging the mains lead.
Ensure the cooker is central in the cabinet and
level.
When the cooker is fully housed screw the
stability screws (supplied with the cooker) into
the side of the cabinet taking care not to distort
the side trims (See Fig. 10). It is advisable to
turn each screw alternately to avoid damaging
the trims.
Switch on the cooker then refer to the operating
instructions.
Fig.8
(Cable not supplied)
Fig.9
Fig.10
39