Porter-Cable PC750AG Instruction Manual page 10

90536090 PC750AG Angle Grinder
11
ASSEMBLY
:
To prevent accidental operation, turn off and unplug tool before
performing the following operations. Failure to do this could result in serious
personal injury.
ATTACHING THE WHEEL GUARD - FIG. 2
:
NEVER GRIND OR BRUSH WITHOUT GUARD IN PLACE.
• Place the tool on a table, with the spindle (9) facing up.
• Place the spring washer (8) over the spindle and locate it on the shoulder (10).
• Place the guard (4) onto the tool as shown.
• Place the flange (7) over the spindle with the protruding pips towards the guard. Make
sure that the holes in the flange align with the screw holes.
• Secure the flange with the screws (6). Make sure that the screws are fully tight and that
the guard can be rotated.
REMOVING THE WHEEL GUARD (FOR SANDING ONLY) - FIG. 3
:
To prevent loss of control, do not set tool down until accessory has
completely stopped turning.
This tool is fitted with a guard. For sanding only, you can remove the guard as follows:
• Remove the outer flange, disc and inner flange if they have been attached.
• Use a screwdriver to remove the screws (6).
• Remove the flange (7), guard (4) and spring washer (8). Store these parts carefully.
ADJUSTING THE GUARD
The guard can be rotated 90°.
• Rotate the guard as required.
FITTING THE SIDE HANDLE
• A three position auxiliary handle (3) is furnished with your grinder and can be screwed
into either side of the grinder housing as well as into the top.
:
This handle SHOULD BE USED AT ALL TIMES to maintain complete
control of the tool. Always make sure the handle is tight.
FITTING AND REMOVING DEPRESSED CENTER WHEELS - FIG. 4 - 6
:
Never use any depressed-center wheels without the proper guard.
FITTING - FIGURE 4,5
• Fit the guard as described above.
• Place the inner flange (11) onto the spindle (7) as shown (fig. 4). Make sure that the
6/6/08 9:13 AM Page 10
10